Service Diagnostic Parameters (Read Only); Flow Measurement Control Parameters (Read Only); Output Control Parameters (Read Only); Hardware / Software Versions (Read Only) - +Gf+ 2298 Bedienungsanleitung

Instruction manual
5.10

Service diagnostic parameters (read only)

Service diagnostic parameters (read only)
P60 Number of operating hours since issuing [h]
P61 The number of operating hours since the last power-on [h]
P62 The number of operating hours of the relay (closed time of contact C2) [h]
P63 The number of switching cycles of the relay
P64 The current temperature of the device's electronics [°C / °F]
P65 The highest temperature of the device ever measured [°C / °F]
P66 The lowest temperature of the device ever measured [°C / °F]
P70 Number of detected peaks (current)
P71 Magnitude of selected echo (raw value)
P72 The amplitude of the selected echo [dB]
P73 The distance of the selected echo [m]
P74 Echo lost/shot ratio
5.11

Flow measurement control parameters (read only)

Service diagnostic parameters (read only)
P76* Measuring height of the flow measurement ('h' value)
P77 TOT1 totalizer (can be cleared)
P78 TOT2 totalizer
5.12

Output control parameters (read only)

Service diagnostic parameters (read only)
P79 Current generator re-measured output current [μA]
P80 Current generator calculated output current [mA]
P81 Relay output status
5.13

Hardware / Software versions (read only)

Service diagnostic parameters (read only)
P94/P95 Software code 2 / 3 (SLAVE MCUs)
P96 Software code 3 (MAIN MCU)
P97/P98 Hardware identification code
Type 2298 80 GHz Radar Level Sensor
* Measuring height required for flow
measurement. This value is the "h"
value in the flow calculation formula.
43