Parkside Performance PPFBSA 12 A1 Originalbetriebsanleitung Seite 30

GB MT
20 Charger
21 Storage case
22 HSS drill
23 Mandrel (polishing disc)
24 Mandrel (cutting and grinding
discs)
25 Milling pin
26 Milling cutter pin
27 Spiral milling pin
28 Circle cutter
29 Cutting disc
30 Plastic brush
31 Polishing sander
32 Felt polishing disc (large)
33 Felt polishing disc (small)
34 Cutting disc (small)
35 Grinding disc
36 Sandpaper
37 Corundum mounted point
38 Silicon carbide mounted point
39 Mandrel (abrasive belt)
40 Grinding belt
41 Polishing compound
42 Mounting key
Fig. B
43 Clamping screw
44 Screw
Description of functions
The device enables clean sanding/
grinding, cutting, polishing, brushing,
engraving and drilling.
Please refer to the descriptions below
for information on how the operating
elements work.
30
Technical data
Cordless Rotary Tool
.................................... PPFBSA 12 A1
Rated voltage U
......................... 12 V ⎓ (direct current)
Rated speed n .......5000-32000 min
Weight with battery (12 V, 2 Ah)
...............................................≈0.58 kg
Tool holder ........................ ≤⌀3,2 mm
Sound pressure level (L
.................................. 73.2 dB; K=3 dB
Sound power level (L
– Measured .............. 84.2 dB; K=3 dB
Vibration (a ) .. 1.130 m/s²; K=1.5 m/s²
h
Battery .......................................Li-Ion
Temperature ............................ ≤50 °C
– Charging ........................... 4 – 40 °C
– Operation .......................-20 – 50 °C
– Storage ............................. 0 – 45 °C
Levels of noise and vibration were de-
termined according to the standards
and regulations in the declaration of
conformity.
The specified total vibration value and
the stated noise emission value have
been measured according to a stand-
ardised test method and can be used
to compare one power tool with an-
other. The specified total vibration
value and the stated specified noise
emission value can also be used for a
provisional assessment of the load.
WARNING! The vibration and
noise emissions may deviate from
the specified values during actual
use of the power tool, depending on
how the power tool is being used. Try
to keep the exposure to vibrations
as low as possible. An example of a
measure to reduce vibration expos-
ure is limiting the working hours. All
parts of the operating cycle have to
be considered while doing so (for ex-
ample, times when the power tool
−1
)
pA
) .....................
WA