57
Loading the feeder
To load the machine feeder with oranges, you can open the Feeder basket (14) door and partially empty
the box of oranges into it. Close the door and finish filling the basket.
Juice extraction unit
Make sure that all the elements that permit cutting the orange, extracting the juice and collecting it are
mounted on the machine. To do this, consult the machine model purchased on the diagram indicated
in section: Unpacking and start-up. Assembly and detachment of components according to model.
Check the state of the containers and filter to guarantee quality juice.
If you have a machine with 1Step kit (19+) you can remove and replace the 1Step kit in just one
step.
Juicing
If you have a machine with:
• Automatic PulpOut System (42+), the pulp and any seeds will be expelled from the left hand side of
the machine.
• SS Tap Up (44U), SS Tap S +plus (44+) or Tank tap (55), read the instructions for use of the Self Service
tap in section Assembly and detachment of components according to model.
• Automatic filling machine, the machine will stop automatically when it reaches maximum level.
Remember to fit the Tank/Cooler buoy (2), following the assembly instructions. You will also have to
select filling quantity.
Waste area
Make sure that the elements that collect the orange peel are correctly positioned.
Check if the tanks are getting full, to prevent the peel from flowing over.
You can also use the new function, Waste Limit, which enables you to programme an alarm so that
the machine will stop when the waste bin is full.
You can select the number of oranges you want to squeeze before the alarm sounds. Once you have
squeezed the amount of oranges programmed, the machine will stop and a warning will appear on the
display so that the operator knows the waste bin has to be emptied.
If you have purchased a machine with Podium, the peel will fall directly into the Peel buckets
To switch the alarm off, press the OK button for approximately 2" until it comes to a stop.