Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Plastic juicer filter (32)
Place on the inside of the juice container (Fig. 2).
Peel bucket (33)
Place the peel buckets under the cover side outlets (Fig. 2 or 3U depending on model).
Drip tray (34)
Place under the juice outlet (Fig. 2 or 3U depending on model).
Self Service Juice container (40)
Assembly (Fig. 12).
Line up the tap detector tube (45) with the hole in the back of the container. Slide it until the
container fixing pins are fully inserted in the latch holes. Press firmly with your right hand on
the front of the container until you hear the click of the latch and then with your left hand until
you hear the click of the left latch. Ensure that it is correctly attached by gently pulling on it.
Important! The incorrect assembly of the container can lead to breaks in the seal and small
!
juice leaks. Always make sure that it is correctly fixed to the body of the machine and that the
container is in good condition.
Note: To ensure the correct fit of the container, it is recommended to keep the fixing latches
clean of juice and/or dirt. Spray a detergent (Zumex Citric Active) in the container fixing holes
and the inner part as shown in picture 3. (Fig. 12). Allow the detergent to work for 1 minute.
Repeatedly activate the latches and wipe away any remaining product with a clean cloth.
Disassembly (Fig. 12).
To disassemble the container, press the left and right latches at the same time. Slide the
container out.
Self Service Sub-filter (41)
Place on the inside of the juice extraction container (Fig. 3U).
Automatic PulpOut System (42+)
With this device pulp and seeds will be removed automatically during the juicing process.
Werbung
