Tank/Cooler Buoy (52)
Tank Model
a) If the support with buoy is loose, loosen the knobs on the support (Fig. 16 (1)).
b) Line up the lugs on the support with the inside of the lid (Fig. 16 (2)).
c) Tighten the knobs (Fig. 16 (2 and 3U)).
d) If a deep clean is necessary, remove the reverse the order of the previous steps and remove the
shaft (Fig. 16 (4)).
Cooler or Tank model
Slacken the upper lugs. Line up the plate with the openings from below. Tighten the upper lugs
again (Fig. 18).
Tank (53)
Use the thread to secure the Self Service tap to the Tank container (Fig. 5+).
Tank Tap (55)
Use the thread to secure the Self Service Tap to the Tank container. Make sure that it is in upright
position (Fig. 17.1).
The Tank Tap can work continuously or discontinuously. Just turn the handle 180º and it will be locked
when the handle is lowered, thus permitting free spout.
For cleaning, you can remove the upper part of the Self Service Tap (Fig. 17.2).
Level detector (56)
This component only needs to be manipulated if a spare part is requested. Remember to place the
detector in the same position as the original detector. If you have a Tank machine, the detector is
located in the upper part; if you have a Cooler machine, it is located in the lower part (Fig. 5+ y 6).
Cooler unit (70)
Place the cooler unit in its housing in the stand (Fig. 6).
Mount the components as indicated in Fig. 18 in this order.
a) Mount the piston-gasket and the lever in the tank following the steps indicated in the enclosed
drawing.