Lower pressing unit (4), Upper pressing unit (5)
Place the pressing units in the shafts (Fig. 1).
If you have a Speed S +plus then refer to the section 1Step kit (19+). Always mount the lower and upper
pressing units of the same side at the same time to make it easier to position them.
Injection Plastic Securing Knob (6)
Screw in the knobs to secure the pressing units and the feeder plate (Fig. 1).
If you have a Speed S +plus then refer to the section 1Step kit (19+).
Left peel ejector (7), Right peel ejector (8)
Assembly of the ejector (Fig. 21).
Place the ejectors on the corresponding side and insert them onto the knobs. Push the ejector
until the blade is fully inserted into the lower pressing unit and the channel makes contact with
the second knob.
Important! If the ejector is not correctly installed as indicated above, the part may be damaged
when the machine is in operation.
If you have purchased the Speed S +plus model, read the 1Step Kit (19+) section.
Disassembly of the ejector (Fig. 21)
Pull the ejector out until it is completely free from the machine.
Important! Remove the ejectors before removing other parts of the juicing unit.
Blade holder (9)
Place the blade carefully on its guide and push inwards (Fig. 1).
Blade holder S
(9+)
+plus
Place the blade carefully on its guide and push inwards (Fig. 1+).
Note: Always insert before inserting the 1Step kit.
45