ZUMEX Speed Up Benutzerhandbuch Seite 50

Disassembly of the Up Tap (13.1)
Hold the tap with one hand while loosening the tap fixing nut with the other hand. After loosening
the tap fixing nut, gently pull the tap out.
Hold the bottle holder with one hand while unscrewing the centring device/bottle holder nut with
the other hand. Pull gently to separate it from the thread of the container.
Important! Use both hands to dismantle the tap and holder to avoid any parts being dropped or
!
injury.
Assembly of the S+ Tap (14.1+)
To install the S+plus tap in the container, hold the tap with both hands, line up the pin with the
hole in the container thread and gently push the tap in. Hold the tap firmly by the bottle holder
with one hand and tighten the tap floating fixing nut with the other hand.
Note: Remember to tighten the floating nut until the threads on the container are no longer visible.
If it is not positioned correctly, the tap sensor will not be activated.
Disassembly of the S+ Tap (14.1+)
Hold the tap with one hand while loosening the tap fixing nut with the other hand.
After loosening the tap fixing nut, gently pull the tap out.
Important! Handle the tap with both hands, do not force the pin or the tap thread. Do not put any
!
weight on the tap.
Tap operation (Fig. 13.2 and 14.2+)
The tap is operated by pressing and releasing for juice extraction.
On the SS S +plus tap (44+), the button is located on the outside. The button can be locked
in the "free spout" position. To do this, turn the ring with the dotted/continuous lines until the
continuous line is over the glass icon. Release the button. It is now locked in position. To release,
simply press the button again.
The Speed S +plus All-in-One machine has a bottle holder that can be removed, if necessary, by
removing the two rear screws.
On the SS Up tap (44U), the button is located on the inside. The button can be locked in the "free
spout" position. To do this, press the button completely and move the metal tab on the side of the
bottle holder/centring device. Release the button. It is now locked in position. To release, simply
press the button again.