Herunterladen Diese Seite drucken

ZUMEX Speed Up Benutzerhandbuch Seite 47

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

Assembly of the 1Step Kit (19+)
a) Place the rear holder (19.2+) on a surface. The metal ejector holders should be face down.
b) Match up the lower and upper pressing units (4 and 5). Line up the circular bases of the
pressing units with the holes on the holder. Note that the faces of the pressing units are
different.
Ensure to mount them as shown in the figure.
d) Line up the protruding cones of the pressing units with the four circular bushes on the
front holder (19.1+).
e) Join both holders with the plastic securing knob (6).
c) Turn the 1step kit 180º and line up the ejectors (7 and 8) with the ejector holders, inserting
the extractor blade into the seal of the lower pressing unit. Ensure that both holders are
inside the ejector channel as shown in image 4.
Disassembly of the 1Step Kit (19+)
c) From the position shown in image 4, pull the ejectors (7 and 8) sideways to remove them from
the metal holders.
a) Turn the kit 180º and unscrew the plastic securing knob (6), which is located behind the
pressing units and holds both metal holders (19.1+ and 19.2+).
b) Carefully pull the front holder (19.1+).
c) Separate the lower pressing unit (4) and the upper pressing unit (5).
Note: To clean the unit, refer to the Cleaning section.
Plastic Juice Container (30)
Make sure that the sealing gasket is correctly mounted on the container (Fig. 11). Then place the
container in the machine. Line up and place under the container on the four lugs that you will see on
the machine (Fig. 2).
Plastic inner filter (31)
Place on the inside of the juice container (Fig. 2).
47

Werbung

loading