Parkside Performance PRDSP 20-Li C2 Bedienungs- Und Sicherheitshinweise Seite 32

Protect the product against shocks
o
and strong vibrations, which occur
especially during transport in
vehicles.
˜ Troubleshooting
WARNING! Risk of accidental contact of spray materials with skin and
m
eye!
Always wear appropriate personal protection equipment as instructed by the
u
chemical manufacturer when using, preparing, handling, spraying, or disposing
of chemicals. This equipment includes at least goggles, gloves, respiratory
protection and protective clothing.
Before starting to ork ith the produ t, s ueeze do n the trigger
u
pressure has been released completely. If the pressure has not been released
beforehand, chemicals may splash out in an uncontrolled manner when
working with the product.
After work, carry out a test run with clean water.
u
Fault
The product cannot
be switched on.
The product does
not spray.
30 GB
Possible cause
The battery
pa k is not
[ ]
inserted properly.
The battery
pa k is empty.
[ ]
No pressure
present.
No chemicals in the
spray tank .
[ 3 ]
Nozzle
a essories or
[ ]
one spray head
[
are blocked.
The small filter
[ ]
is blocked.
Secure the product against slipping
o
and tipping.
Solution
Insert the battery pa k
Charge the battery pa k
S it h o the produ t Press the on o
s it h .
[ ]
ill the spray tank
S it h o the produ t, remove the
battery pa k and release the
[ ]
pressure.
Clean the nozzle a
]
one spray head
through them see "Cleaning and are" .
S it h o the produ t, remove the
battery pa k and release the
[ ]
pressure.
Clean the small filter
ater using a brush see "Cleaning and
care").
until the
[ ]
properly.
[ ]
.
[ ]
with chemicals.
[ 3 ]
essories or the
[ ]
by pushing a needle
[ ]
under running
[ ]