Parkside Performance PRDSP 20-Li C2 Bedienungs- Und Sicherheitshinweise Seite 18

Do not lift or carry the product by
the hose or shut o valve. Carry
the product by the handle and the
shoulder strap only.
Never use the product in a room
where there is a danger of explosion
or in the vi inity of ammable li uids
or gases.
Do not immerse the product in water
or other liquids. Do not place the
product where it can fall or be pulled
into a tub or sink.
Only operate the product when it is
in an upright position.
Do not operate the product with an
empty spray tank.
It is necessary to provide the
appropriate training in safe operation.
Do not use the product while tired,
ill or under the in uen e of al ohol,
drugs or medicaments.
Always carry out a visual inspection
before using the product. Do not use
the product if it is damaged. If the
product is damaged, have it checked
by ualified personnel.
Always check the product for leaks.
If any are found, correct them before
using the product.
When assembling or removing
accessories, do not point them
towards yourself or other persons.
The product must only be operated
by 1 person at a time. Nobody else
must be ithin a radius of 1 metres
at the same time.
If there is no spray coming out from
the nozzle or the spray amount is
decreased, the hose and spray
system may be blocked. Rinse and
clean all parts of the hose and spray
system shut o valve, small filter,
nozzle pipe, hose, nozzle) with clean
water.
16 GB
After the product has been stored
for a long time e.g. during inter , fill
the spray tank
3 ] [
Carry out a test run to check if there
are any leakages or cracks.
Release the residual pressure in
the spray tank after each use and
especially before removing the spray
tank cover. Do so by pressing the
trigger.
Do not modify the product under any
ir umstan e. Modifi ations may
result in serious injury.
All servicing and maintenance,
other than the items listed in this
instruction manual, should be
performed by an authorised service
centre.
Only use spare parts and
accessories provided by the
manufacturer. All other repairs
shall only be carried out by an
authorised service centre. Improper
maintenance, use of non-conforming
components and removal of
safety devices can lead to a
hazardous situation, such as death,
life-threatening injuries and damage.
Check the volume application rate
during operation.
˜ Vibration and noise
reduction
To reduce the impact of noise and
vibration emission, limit the time of
operation, use low-vibration and
low-noise operating modes and wear
personal protective equipment.
Take the following points into account
to minimise the vibration and noise
exposure risks:
Only use the product as intended by
its design and these instructions.
Ensure that the product is in good
condition and well maintained.
with clean water.