Scheppach Air Case Original Bedienungsanleitung Seite 26

• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
13. Troubleshooting
Fault
The compressor does not start.
The compressor starts but
there is no pressure.
The compressor starts, pres-
sure is shown on the pressure
gauge, but the tools do not
start.
26 | GB
Possible cause
No supply voltage.
Insufficient supply voltage.
Outside temperature is too low.
Motor is overheated.
The non-return valve leaks.
The seals are damaged.
The hose connections have a leak.
A quick-lock coupling has a leak.
www.scheppach.com
Remedy
Check the supply voltage, the power
plug and the socket-outlet.
Make sure that the extension cable is
not too long. Use an extension cable
with large enough wires.
Never operate with an outside temper-
ature of below +5° C.
Allow the motor to cool down. If
necessary, remedy the cause of the
overheating.
Have a service center replace the
non-return valve.
Check the seals and have any
damaged seals replaced by a service
center.
Check the compressed air hose and
tools and replace if necessary.
Check the quick-lock coupling and
replace if necessary.