Merach MR-R11 Benutzerhandbuch Seite 23

INSTRUCTION OF MONITOR
D. Steps C and D continue to repeat in a cycle, with each cycle counting adding 1, until the display
shows "WORK 08/08" after the 8th cycle, entering the end screen.
E. During the execution of WORK function, enter standby mode 4 minutes after no keys are pressed
and no signals are input.
F . The REST function does not enter SLEEP due to no keys being pressed or signals being input.
(2) INTERVAL 20/10
A. Switch to select the 20/10 function (Figure 12). Press MODE KEY to start the 20/10 function LCD
screen (display shows "READY" blinking), TIME window displays a 3-second countdown, and the
buzzer sounds for 0.5 seconds every second.
B. After READY for 3 seconds, the display shows "WORK 01/08," and TIME starts counting down for
20 seconds (Figure 13). All values start counting display based on calculation values, and in a
shared window, the display switches every 5 seconds.
C. The display shows "REST 01/08," and TIME starts counting down for 10 seconds (Figure 14). All
values start counting display based on calculation values, and in a shared window, the display
switches every 5 seconds. In the last 3 seconds, the display shows "READY" blinking.
D. Steps C and D continue to repeat in a cycle, with each cycle counting adding 1, until the display
shows "WORK 08/08" after the 8th cycle, entering the end screen, and the buzzer sounds for
0.5 seconds.
E. During the execution of WORK function, enter standby mode 4 minutes after no keys are pressed
and no signals are input.
F . The REST function does not enter SLEEP due to no keys being pressed or signals being input.
Figure 12
(3) INTERVAL CUSTOM
A. Switch to select the CUSTOM function; the display shows CUSTOM blinking. Press the MODE KEY
to enter the CUSTOM setting function (Figure 15).
B. The display shows "SET ROUND," and the TIME window displays 01 blinking (Figure 16). Press SET
to set the ROUND; the ROUND setting range is 01~99 and can be cyclically set. After pressing
MODE KEY , the buzzer sounds for 0.5 seconds and enters the next option setting.
C. The display shows "SET WORK," and the TIME window displays 0:05 blinking. Press SET to set
EN 15
WORK TIME; the WORK TIME setting range is 0:05~10:00 and can be cyclically set. After pressing
MODE KEY , the buzzer sounds for 0.5 seconds and enters the next option setting (Figure 17).
Figure 13 Figure 14 Figure 15 Figure 16 Figure 17