Cleaning The Sensors - Siguro Sgr-Rv-S900B Bedienungsanleitung

After removing the mops, the mop holders can be carefully wiped with a damp, soft
cloth. Do not use brushes, wire scrubbers, etc. to avoid damaging the Velcro fasteners.
Note:
The mops should not be machine-washed or -dried.
Cleaning the Centre Rotary Brush
1. Press the locks of the central rotary
brush cover and tilt it open.
2. Grab the central rotary brush at one
end and carefully remove it from its
mounting in the suction aperture.
3. Clean tangled hair, fur and other detritus
from the rotary brush and its bearings.
4. Clean the brush bay with a dry cloth
and check the suction aperture for
obstructions.
5. Replace the rotary brush in its
mounting, then replace the cover plate.
Push down gently until you hear a click. This indicates the brush is secure.

Cleaning the Sensors

It is important to regularly clean the sensors on the vacuum cleaner and the charging
station to ensure the vacuum's reliable navigation. Wipe the sensors with a soft, dry
sponge.
AI camera
Bottom sensors
Vacuum cleaner charging contacts
Laser module
Side sensors
Charging station contacts
EN - 21
EN