Use; Automatic Cleaning Mode - Siguro Sgr-Rv-S900B Bedienungsanleitung
Robotersauger
Inhaltsverzeichnis
Verfügbare Sprachen
Verfügbare Sprachen
EN
docked, the station will clean the vacuum, emptying the dust container and
washing and cleaning the mops. Automatic charging will then start.
USE
Power On / Off
Long-press
vacuum is ready to use.
To switch off the vacuum cleaner, press and hold
out. The vacuum cleaner will shut down.
Note:
The vacuum cleaner cannot be switched off while it is charging.
Note:
If the charge level is too low, the vacuum cleaner will not start.
Standby Mode and Automatic Shutdown
When cleaning remains interrupted for more than 10 minutes, the button backlight
will go out and the vacuum cleaner will go to standby. Press any button to switch the
vacuum back to ready condition.
After the vacuum cleaner has been on standby for 24 hours, it will automatically switch
off. To turn it on, press and hold
Automatic Cleaning Mode
While the vacuum is on, press
first going around the walls of the room, then cleaning the room on a Z-shaped path.
Automatic cleaning is the default mode.
If cleaning the area once takes less than 10 minutes, the vacuum cleaner will clean it
again. This is normal behaviour.
Starting Local Cleaning
While the vacuum is on, press
cleaning. The vacuum cleaner will clean a 1.5 × 1.5 m square area centred on its starting
position. When done, it will return to the starting point.
Cleaning Pause / Restart
To interrupt cleaning, press
If cleaning remains interrupted for more than 10 minutes, the button backlight will
go out and the vacuum cleaner will go to standby. Press any button to reactivate it. To
continue cleaning, press
Manually Seek Charging Station
Press
while the vacuum cleaner is in operation. The vacuum cleaner will stop clean-
ing and automatically seek the charging station, where it will park to recharge.
to power on the appliance. The
.
. The vacuum cleaner starts automatic cleaning by
for 3 seconds. The vacuum cleaner will start local
. To resume cleaning, press
.
and
buttons will light up. The
until the button backlight goes
again.
EN - 16
Inhaltsverzeichnis
Fehlerbehebung
