Filling The Clean Water Tank - Siguro Sgr-Rv-S900B Bedienungsanleitung

EN
When the vacuum cleaner has finished cleaning, it automatically locates the charging
station, where it parks itself so that it can recharge and is ready for further use. For this
reason, keep the charging station plugged in at all times. Once the vacuum is fully
charged, charging stops automatically.
If the vacuum cleaner's charge level falls too low during operation, the vacuum cleaner
will automatically stop cleaning and seek the charging station to park and recharge.
After charging, the vacuum cleaner will start again and continue cleaning where it left
off.
Note:
If the vacuum cleaner cannot find the charging station, it will return to
where it stopped cleaning. You will then need to manually insert the
vacuum cleaner into the charging station. If the vacuum cleaner runs out
of power while looking for the charging station, it will stop in place. In this
case, too, you will have to manually insert it into the charging station.
Note:
During prolonged disuse, recharge the vacuum once every 2 to 3 months
to extend the useful life of the battery pack.
Warning:
Do not move the charging station while the vacuum cleaner is in opera-
tion.
Status Indication by Button Backlight
Backlight flashes slowly: the vacuum cleaner is charging.
Backlight glows steadily: the vacuum cleaner is charged and ready to use.
Charging Station LED Indicator
LED glows blue: charging station status is nominal.
LED glows red: charging station malfunction.

Filling the Clean Water Tank

The clean water tank should be filled with clean, cold water before using the vacuum
cleaner to vacuum and wipe, or just to wipe.
1. Open the charging station lid and remove the clean water tank.
2. Open the tank lid and pour in clean, cold water up to the MAX line.
3. Close the lid. Make sure the lid locks have engaged and the lid is secure.
4. Return the tank into the charging station and close the lid.
5. When the tank is low, a refill alert will appear on your phone app. Follow the same
procedure to refill.
Warning:
Only fill the tank with clean, cold water. Do not use warm or hot water. Do
not use detergents or other chemicals. Doing so may severely damage
the system.
Note:
The app allows setting the mop soaking frequency, hot water mopping,
etc.
EN - 14