General Cleaning Procedure - Siguro Sgr-Rv-S900B Bedienungsanleitung

Preparing the Room for Cleaning
Before using the vacuum, take these steps to avoid damage to the appliance or other
property, or hazardous situations.
1. Clear the floor of all cables and small items that might entangle the vacuum.
2. Secure any free carpet edges on which the vacuum might trip and tassels it might
suck in. The vacuum is not designed to clean carpets with pile height exceeding 26
mm (1 in).
3. Prevent the vacuum from attempting to enter spaces with less than 70 mm
clearance; it might get stuck. If necessary, block off such spaces by setting a
suitable ground-standing object before them.
4. The vacuum is not designed for cleaning wet areas. Do not expose it to water or
moisture.
5. The vacuum can drive over obstacles up to 16 mm high. Remove taller obstacles if
necessary.
6. The vacuum is equipped with surface sensors, designed to keep it from falling off
stairs etc. These sensors' readings can be fouled by dirt on the sensor eye, dark
or reflective floor materials, and other adverse conditions. We thus recommend
blocking off areas where the vacuum might fall off a step or ledge with suitable
obstacles.

General Cleaning Procedure

• Regardless of mode, the vacuum cleaner uses pathfinding algorithms to ensure
efficient cleaning of the room or area.
• Let the vacuum cleaner charge fully before first use.
• To start cleaning, use the button on the vacuum cleaner or the phone app.
• When total cleaning time is less than 10 minutes, the vacuum cleans the area
twice. This is normal behaviour.
• When the vacuum detects a low charge, it stops cleaning and seeks out the
charging station. Once sufficiently charged, it will return to where it left off and
resume cleaning.
• When the vacuum detects its dust container is full, it stops cleaning and seeks out
the charging station. Once it docks, the charging station will automatically transfer
the dust from the container into its built-in dust bag. This process produces a
vacuum sound that may be louder than the vacuum cleaner's normal operating
noise. This is normal behaviour.
• When the vacuum detects its water tank is running low, it stops cleaning and seeks
out the charging station to refill. Once done, it will return to where it left off and
resume cleaning.
Note:
You can set the water refill interval and the amount of water to soak the
mops and wipe the floor in the app on your phone.
• In vacuum-and-wipe mode, the vacuum cleaner can identify the type of flooring
it is on. When it rolls onto a carpet or rug, it automatically raises the mops. There
is thus no need to take them off manually. After rolling back onto smooth flooring
(e.g. tiles), it automatically lowers the mops again and continues wiping.
• Even so, we recommend removing smaller rugs with pile height over 12 mm and
doormats before starting the cleaner. Alternately, surround these with a virtual wall
in the app so the vacuum avoids them.
• When cleaning is complete, the vacuum seeks out the charging station. Once
EN - 15
EN