Troubleshooting; Disposal/Environmental Protection - Parkside Pstda 20-Li C3 Originalbetriebsanleitung

GB MT

Troubleshooting

The following table will assist you in fixing faults:
Problem
Device does not start
Device works with inter-
ruptions
Poor sawing performance
Saw blade quickly be-
comes blunt
Disposal/
environmental
protection
Remove the battery from the device
and recycle the device, battery,
38
Possible cause
Rechargeable battery (4)
not inserted
On/Off switch (2) is
broken
Rechargeable battery (4)
discharged
Defective motor
Internal loose contact
On/Off switch (2) is
broken
Saw blade (16/17/18) un-
suitable for the workpiece
to be processed
Saw blade (16/17/18)
blunt
Low battery power
Incorrect sawing speed
Saw blade (16/17/18) un-
suitable for the workpiece
to be processed
Too much pressure ap-
plied
Sawing speed too high
accessories and packaging in an
environmentally-friendly manner.
Error correction
Inserting the battery,
p. 36
Contact the service
centre.
Charge the battery (see
the separate operating
instructions for the re-
chargeable battery and
charger)
Contact the service
centre.
Contact the service
centre.
Contact the service
centre.
Use a suitable saw blade
(16/17/18)
Use a new saw blade (16/
17/18)
Charge the battery (see
the separate operating
instructions for the re-
chargeable battery and
charger)
Adjust sawing speed
Use a suitable saw blade
(16/17/18)
Reduce the pressure
Reduce the sawing speed
Waste electrical and electron-
ic equipment (WEEE) must not
be disposed of with domestic
waste.