Parkside Performance PRDSP 20-Li C2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 66

Protect the product against shocks
o
and strong vibrations, which occur
especially during transport in
vehicles.
˜ Troubleshooting
WARNING! Risk of accidental contact of spray materials with skin and
m
eye!
Always wear appropriate personal protection equipment as instructed by the
u
chemical manufacturer when using, preparing, handling, spraying, or disposing
of chemicals. This equipment includes at least goggles, gloves, respiratory
protection and protective clothing.
Before starting to work with the product, s ueeze down the trigger
u
pressure has been released completely. If the pressure has not been released
beforehand, chemicals may splash out in an uncontrolled manner when
working with the product.
After work, carry out a test run with clean water.
u
Fault
The product cannot
be switched on.
The product does
not spray.
64 GB/IE
Possible cause
The battery
pack is not
[ ]
inserted properly.
The battery
pack is empty.
[ ]
No pressure
present.
No chemicals in the
spray tank .
3 ] [
Nozzle
accessories or
[ ]
cone spray head
[
are blocked.
The small filter
[ ]
is blocked.
Secure the product against slipping
o
and tipping.
Solution
Insert the battery pack
Charge the battery pack
Switch o the product Press the on o
switch .
[ ]
Fill the spray tank
Switch o the product, remove the
battery pack and release the
[ ]
pressure.
Clean the nozzle accessories
]
cone spray head
through them see "Cleaning and care" .
Switch o the product, remove the
battery pack and release the
[ ]
pressure.
Clean the small filter
water using a brush see "Cleaning and
care").
until the
[ ]
properly.
[ ]
.
[ ]
with chemicals.
[ 3 ]
or the
[ ]
by pushing a needle
[ ]
under running
[ ]