Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Ice Making Assembly System Cleaning by Using Nu-Calgon
Nickle Safe Ice-machine Cleaner (Better using automatic water
supplying)
Minerals that are removed from water during the freezing cycle will eventually
form a hard scaly deposit in the water system. Cleaning the system regularly
helps remove the mineral scale buildup. How often you need to clean the
system depends upon how hard your water is. With hard water of 4 to 5
grains/liter, you may need to clean the system as often as every 6 months.
Turn off the ice maker. Keep the ice maker connect to the main water supply
1.
and drainpipe. But shut off the water faucet of main water supply.
Open the door and scoop out all of the ice cubes. Either discard them or save
2.
them in an ice chest or cooler.
3.Making the cleaning solution. Please mix the Nu-Calgon Nickle Safe Ice
Machine Cleaner with water to make the cleaning solution.
Wear rubber gloves and safety goggles( and/or face
shield) when handing Ice Machine Cleaner or sanitizer.
Use a plastic or stainless container with more than 4 liters capacity, mix 300
ml Nu-Calgon Nickle Safe Ice-machine Cleaner with 2.8 liters warm water
about 50-60 ℃.
Then divide them for 2 shares equally in 2 cups. It is better to keep the
temperature of each cup of the cleaning solution.
4.Check to be sure that the water drain pipe of the water tank has been
installed properly in the slot of the tank wall. Then Pour one cup of Nickel-
Safe Ice Maker Cleaning Solution into the water tank. Wait about for 5
minutes.
Turn on the power to the ice maker, then press "TIMER/ CLEAN"button on
5.
control panel for more than 5 seconds, to enter the self-Cleaning program.
Same as above explanation, the water pump runs for 8 minutes and stops for
3 minutes, one cycle, again one cycle. The total duration time is 20 minutes
for one self-cleaning program.
During this process, the "
and the digit window will indicate the left time.
WARNING
"symbol will always be on during this period,
23
Werbung
