Herunterladen Diese Seite drucken

HOMCOM HZB-30F Bedienungsanleitung Seite 20

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

through the silicone pipe flow into the ice bin, at last can be drained out the
unit through the water drain port at unit back.
Normal Sounds
Your new ice maker may make sounds that are not familiar to you. Most of the
new sounds are normal. Hard surfaces like the floor, walls and cabinets can
make the sounds seem louder than they actually are. The following describes
the kinds of sounds that might be new to you and what may be making them.
- You will hear a swooshing sound when the control valve opens to let water
flow into the
water tank for each ice-making cycle.
- Rattling noises may come from the flow of the refrigerant or the water line.
Items stored on top of the ice maker can also make noises.
- The high-efficiency compressor may make a pulsating or high-pitched
sound.
- Water running from the water tank to the evaporator plate may make a
splashing sound.
- Water running from the evaporator to the water tank may make a splashing
sound.
- As each cycle ends, you may hear a gurgling sound due to the refrigerant
flowing in your ice maker.
- You may hear air being forced over the condenser by the condenser fan.
During the harvest cycle, you may hear the sound of ice cubes falling into
the ice storage bin.
- When you first start the ice maker, you may hear water running
continuously. The ice maker is programmed to run a rinse cycle before it
begins to make ice.
Preparing the Ice Maker for Long Storage
If the ice maker will not be used for a long time, or is to be moved to another
place, it will be necessary to drain out all of the water in the system.
Allow all of the ice cubes have been ejected from the evaporator of ice
1.
maker.
Turn off the unit, and unplug the power cord.
2.
Drain out all of the water inside the unit according to section "Water
3.
Drainage". When all of the water has been drained out, to install back the
water drain pipe of the water tank..
Disconnect the water drainage pipe to the main drain pipeline or floor
4.
drain, plug on the drain cap again.
Drop the door open to allow for circulation and prevent from molding and
5.
mildewing.
Leave the power cord disconnected until ready to reuse.
6.
Dry the interior & wipe the outside of the unit.
7.
Put a plastic bag on the unit to resist out dust & dirty.
8.
19

Werbung

loading

Diese Anleitung auch für:

Hzb-38f800-254v70800-254v90