Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING PROCEDURES & MAINTENANICE
UNPACKING YOUR ICE MAKER
Remove the exterior and interior packaging. Check if all the accessories,
1.
including instruction manual, ice scoop, white water supplying hose, 1/4
inches to 1/2 inches water quick connector and the water draining pipe,
etc., are inside or not. If any parts are missing, please contact our
customer service.
Remove the tapes for fixing the door and inner cabinet, ice scoop, etc..
2.
Roughly clean the inner cabinet & ice scoop with wet clothe.
Put the ice maker on a level & flat floor, without direct sunlight and other
3.
sources of heat (i.e.: stove, furnace, radiator). Make sure that there is at
least 20cm gap between the air outlet and the obstacles, and at least 5 cm
between Left/Right side and the wall.
Allow 4 hours for the refrigerant fluid to settle before plugging the ice
4.
maker in if the unit maybe fall upside down during shipping or
transportation.
The appliance must be positioned so that the plug is accessible.
5.
WARNING:
Only use drinking water.
For manual water supplying, fill with potable water only.
For automatic water supplying, connect to the potable main water
supply only.
INSTALLATION LOCATION REQUIREMENT
This unit is not for outdoor use. Keep the proper room temperature and inlet
a)
water temperature according to above specification table. Otherwise it will
affect the ice making performance.
This unit should not be located near any heat resource.
b)
The unit should be located on a firm & level foundation at normal counter top
c)
height.
There must be at least 15CM clearance at rear side for connection and 20
d)
CM clearance in front to open the door and keep good air circulation.
Do not put anything on the top of the ice maker.
e)
Installation clearance
top view (mm)
Side view (mm)
11
Werbung
