HOMCOM HZB-30F Bedienungsanleitung Seite 13

To ensure proper ventilation for your ice maker, the front of the unit must be
completely unobstructed (at least 20CM free space). Allow at least 15 cm
clearance at rear, and 5 cm of two sides for proper air circulation. And allow
about 50cm high space at top to fill water freely from unit top when using
manual water supply way and for proper air circulation. The installation
should allow the ice maker to be pulled forward for servicing if necessary.
When installing the ice maker under a counter, follow the recommended
spacing dimensions shown above. Place electrical and drain fixtures in the
recommended locations as shown.
Choose a well-ventilated area with temperatures above 10℃ and below 32℃.
This unit
MUST be installed in an area protected from some elements, such as wind,
rain, water spray or drips.
The temperature of the water feeding into the ice maker should be between
5℃ and 25℃
for proper operation.
ELECTRICAL REQUIREMENT & CONNECTIONS
WARNING: THIS UNIT MUST BE EARTHED.
Plug into a grounding wall outlet.
Never remove the ground prong.
Use separate power supply or receptacle. Never use an
adapter.
Never use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your ice maker into its final location, it is important to make
sure you have the proper electrical connection.
It is recommended that a separate circuit, serving only your ice maker, be
provided. Use receptacles that cannot be turned off by a switch or pull chain.
If the supply cord or plug to be replaced, it should be done by a qualified
service engineer.
This appliance requires a standard 220-240Volt, 50Hz electrical outlet with
good grounding means.
Recommended grounding method
For your personal safety, this appliance must be properly grounded. This
appliance is equipped with a power supply cord having a grounding plug. To
minimize possible shock hazard, the cord must be plugged into a mating
grounding-type wall receptacle, grounded in accordance with the National
Electrical Code and local codes and ordinances. If a mating wall receptacle
is not available, it is the personal responsibility of the customer to have a
properly grounding wall receptacle installed by a qualified electrician.
Electrical Shock Hazard
12