HOMCOM HZB-30F Bedienungsanleitung Seite 19

this button once again to cancel the Timer setting, also
the above number will disappear; And also the second easy way to cancel the
OFF-Timer is to press the "ON/OFF" button, it will cancel the ON-TIMER setting
by force, also will turn off the unit.
Internal LED light operation
When the unit is plugged on, press the "LIGHT" button on the operation panel
once to lighten the LED light inside the ice bin and the "
display window will also be on. Press this button once again, the LED light and
the " " symbol will be off at same time. NOTE: If you press the "LIGHT"
button for more than 5 seconds, the ambient can be changed between
Centigrade degree and Fahrenheit degree（between ℃ and ℉）。
ERROR code of unit breakdown
When the unit is breakdown, the error code will display in the left side of LCD
display window.
E1 means the sensor of ambient temperature is malfunction。
E2 means that ice making program is abnormal, including too big ice-
cube,no ice-cube falling down, or not making ice cube, etc.
NOTE: During the ice cube making process, press "ON/OFF" button for more
than 5 seconds, the unit will jump into the ice-harvest process . After the ice
harvest process is completed, the uni will recover to ice making process.
Water Drainage
Make sure the water drainage pipe has correctly connected at the unit
back first.
You can drain the the water in ice storage bin through the white drainage
A.
pipe connected on the back drainage port. Make sure not to set the white
drainage pipe too high.
For the water in the water tank,you can pull out the silicone pipe on the right
B.
side of the water tank indicating "H" in above illustration to drain out the
cleaned water in the water tank, till the silicone pipe extend completely, the
water can flow out to ice bin. Then the water can be drained out through the
the water drain port at unit back.
Reminding: Clean the water tank frequently, it can improve the ice-cube
quality and the unit and its water circulation pump can work much longer.
For the water in water charging tank, pull out the silicone pipe on the right
C.
side of the water tank indicating "H" in above illustration, then plug on the
unit, let the unit run at ice-making program or self-cleaning program, the
water will flow into the water tank, again
" symbol on the LCD
18
the " " and