HOMCOM HZB-30F Bedienungsanleitung Seite 17

I :Manual water supplying symbol; O: Automatic water supplying
symbol;
Arrow of this symbol flashes, means the water is flowing into the
water tank.
If this whole symbol keeps displaying, means no main water supplying at
present.
Ice-cube symbol, when it rotate, means unit is making the ice cube;
and it flashes, means the unit is in ice harvest process.
℃
Centigrade(ambient temperature）
M
unit of minute（ice-making setting and countdown time）
Plug on the main power supply plug, then press "ON/OFF" button on the
1.
control panel to begin the ice making cycle. The unit ON/OFF state symbol
will keep lighting on, the left number in the LCD display window displays the
present ambient temperature, and the right number displays the present
ice-making setting, and the ice-cube symbol rotates. When the left number
change to flash, then the number means the countdown time to complete
one ice making cycle.
Each ice making cycle will last about 11 to 20 minutes, depending on the
2.
ambient temperature and the water temperature. And for the first time,
according to the initial water temperature, ice-making last time will be a little
longer.
When the ice-making process is over, then switch to ice-harvest process.
3.
During the ice-harvest process, the ICE cube symbol change rotating to
flash. At same time, the arrow on the manual filling water symbol will start to
flash, the water will flow into the water tank again till the floating ball of water
level switch rises up to the highest position, then the water stop flowing and
the whole manual filling water symbol will disappear.
When the ice-harvest finish, the Ice-full detecting plate will rotate downward
once, then recover to the original position and enter to the next ice-making
process.
If after the rotation of the Ice-full detecting plate, it is pressed by the ice
cube and can't recover to the original position, means the the ice bin is full of
the ice cube and it will stop making the ice automatically.
When the "ICE-FULL " symbol display is on, the unit stops running. And if
4.
you move away the ice cube, the unit will start to make the ice cube again.
But it will restart only after 3 minutes interval of compressor running.
During the ice-making process, press the "+" or "-" button to adjust the ice-
5.
making process duration period length, then to change the thickness of the
ice cube. Press the "+" or "-" button, the right digit will flash, the default
setting is zero, 1 minute will add or decrease to each ice making process per
each pressing of "+" or "-" button.
H
unit of hour（setting the timer）
16