HOMCOM HZB-30F Bedienungsanleitung Seite 14

CLEANING YOUR ICE MAKER BEFROE FIRST USING
Before using your ice maker, it is strongly recommended to clean it thoroughly.
Open the ice taking door.
1.
Clean with diluted detergent, warm water and a soft cloth.
2.
Repeatedly clean the water contacting inner parts, use the water or the wet
3.
clothe to scrub the relevant parts, then use the dry clothe to dry them.
You can pull the Water drain pipe of the water tank indicating "H" in above
4.
illustration to drain out the cleaned water in the water tank, then next to
clean inner ice-storing bin, till all of inner parts are cleanly, then drain out all
of the cleaned water from the water drain port located at unit back indicating
"8"in above illustration. And must to install back the water drain pipe of the
water tank and the cap of the unit water drain port, otherwise, the unit will
not make the ice normally.
And suggest that you should discard the ice-cube made by the first ice
making cycle after cleaning.
Note: Please see the section "Water Drainage" in this manual to drain out
the cleaned water.
The outside of the ice maker should be cleaned regularly with a mild
5.
detergent solution and warm water.
Dry the interior and exterior with a clean soft cloth.
6.
OPERATION YOUR UNIT
WATER CONNECTION FOR YOUR ICE MAKER
Important: Be sure to use the new hose-sets supplied with the appliance to
connect to water mains and that old hose-sets should not be reused.
1. Connect the water supplying hose to the unit (For automatic water
supplying)
Step 1: First remove the tape on the water inlet port for water supply (indicated in
the following illustration "B") located at unit back, then use your other hand's finger
to press the out circle Step 2: Insert the one end of the white water hose into the
water inlet port, and push inward completely, and install back the clipper, then
water hose connection is completed.
Unit Back View
STEP 1: Remove the
tape first
Water inlet port on
the unit back
Remove the clipper
first
13
STEP 2: Insert the
water hose
Then install back the clipper
White water
hose(accessory)
First insert the water hose
inward completely