HOMCOM HZB-30F Bedienungsanleitung Seite 18

After 5 second of setting, the new setting will be remembered by the system.
6. The bad water quality will cause the bad quality of ice cube, and reduce the
transparency of the ice cube.
Automatic self-cleaning program
Start the self-cleaning program:
After connecting all of the water pipe, plug on the main power supply plug, then
press"TIMER /CLEAN"button on control panel for more than 5 seconds, to
enter the Self-Cleaning program. And the symbol will always be on during
" "
this period, the left digit will indicate the left time. The total duration time is 20
minutes for one self-cleaning program.
Cancel the self-cleaning program:
It takes about 20 minutes to complete one self-cleaning program. When the
program is over, the system will be in standby mode automatically. And also
you can press the "ON/OFF" button on control panel to cancel the self-cleaning
program by force.
Timer setting operation
Delay time range: 1-24 hours, Default time: 1 hour
How to set the ON-Timer: During the unit is in standby mode, press the
"TIMER/CLEAN"
button to set the ON-Timer. The " symbol will start to be on, the number
"
"1" above the symbol will flash to display the set delay time. During the number
flashing, press+"、 "-"button to change the delay time of the timer, 1 hour
increasing or decreasing per each pressing of "+" or "-" button. Five seconds
after setting, your desired setting will be remembered.
How to cancel the ON-Timer:
Press the "TIMER/TIMER" button, the number above the symbol will
" "
flash to display the present delay time of your ON-Timer, and press this button
once again to cancel the Timer setting, also the symbol and the
" "
number will disappear. And the second easy way to cancel the ON-Timer is to
press the "ON/OFF" button, it will cancel the ON-TIMER setting by force.
How to set the OFF-Timer：
When the unit is working, press the "TIMER/CLEAN" button to set the OFF-
Timer. The " " symbol will start to be on, the number "1" above the
symbol will flash to display the setting delay time. During the number flashing,
press+"、"-"button to change the delay time of the timer, 1 hour increasing or
decreasing per each pressing of "+" or "-" button. Five seconds after setting,
your desired setting will be remembered.
How to cancel the OFF-Timer:
Press the "TIMER/TIMER" button, the number above the " "symbol will
flash to display the present delay time of your OFF-Timer, and press
17