Herunterladen Diese Seite drucken

Atlas Copco Power Focus 4002 Compact Original-Produktanweisungen Seite 6

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 17
Safety Information
4.
The Autoset symbol LED lights up (the LED is
placed at the very bottom on the right side of
the front panel)
5.
Make 5-8 tightening until the LED goes out
Press the RESULT key
6.
Optimum performance has been found and the sys-
tem is ready for production.
Preventing ESD problems
The components inside the tool and controller are
sensitive to electrostatic discharge. To avoid future
malfunction, make sure that service and mainte-
nance is carried out in an ESD approved work en-
vironment. The figure below shows an example of
an appropriate service work station.
Useful information
Log in to Atlas Copco www.atlascopco.com
You can find information concerning our products,
accessories, spare parts and published matters on
our website.
Ergonomic guidelines
Consider your workstation as you read through this
list of general ergonomic guidelines and see if you
can identify areas for improvement in posture,
component placement, or work environment.
• Take frequent breaks and change work posi-
tions frequently.
• Adapt the workstation area to your needs and
the work task.
• Adjust for convenient reach range by deter-
mining where parts or tools should be lo-
cated to avoid static load.
• Use workstation equipment such as tables
and chairs appropriate for the work task.
• Avoid work positions above shoulder level or
with static holding during assembly operations.
6
© Atlas Copco Industrial Technique AB - 9836 4581 00
Power Focus 4002 Compact
• When working above shoulder level, reduce
the load on the static muscles by reducing
the weight of the tool, using for example
torque arms, hose reels or weight balancers.
You can also reduce the load on the static
muscles by holding the tool close to the
body.
• Make sure to take frequent breaks.
• Avoid extreme arm or wrist postures, par-
ticularly for operations requiring a degree
of force.
• Adjust for convenient field of vision by mini-
mizing movement of the eyes and head during
the work task.
• Use the appropriate lighting for the work task.
• Select the appropriate tool for the work task.
• Use ear protection equipment in noisy environ-
ments.
• Use high-quality inserted tools or consumables
to minimize exposure to excessive levels of vi-
bration.
• Minimize exposure to reaction forces.
• When cutting:
A cut-off wheel can get stuck if the wheel is
either bent or if it is not guided properly.
Make sure to use the correct flanges for cut-
off wheels and avoid bending the wheel
during cut-off operation.
• When drilling:
The drill might stall when the drill bit
breaks through. Makes sure you use support
handles if the stall torque is too high. The
safety standard ISO11148 part 3 recom-
mends using something to absorb the reac-
tion torque above 10 Nm for pistol grip
tools and 4 Nm for straight tools.
• When using direct-driven screw or nutrun-
ners:
Reaction forces depend on tool setting and
joint characteristics. The ability to bear re-
action forces depends on the operator's
strength and posture. Adapt the torque set-
ting to the operator's strength and posture
and use a torque arm or reaction bar if the
torque is too high.
• Use dust extraction system or mouth protection
mask in dusty environments.

Werbung

loading

Diese Anleitung auch für:

Power focus 4002 c-hw