Werbung
7
RX DCS
8
TX CTCSS
9
TX DCS
10
Signaling
11
SP-Mute
12
Scan Add
13
Scan Priority
14
TX Admit
•
OFF
•
017N-754N
•
OFF
•
67-254
•
OFF
•
023N-754I
•
DTMF: Set a DTMF ID as the default call ID for the
current channel.
•
2Tone: Set a 2Tone as the default call ID for the
current channel.
•
5Tone: Set a 5Tone as the default call ID for the
current channel.
•
MDC: Set a MDC as the default call ID for the current
channel
OFF: You can hear the call once the channel receive
matched carrier.
QT: You can hear the call when receive matched
CTCSS/DCS signal.
•
Op onal Signal: You can hear the call when receives
a matched signaling.
QT+DTMF: You can hear the call when receives a
matched CTCSS/DCS and matched signaling.
•
OFF: Disable scanning of the current channel
•
ON: Add current channel to scan group
•
OFF: No channel is set as Priority Channel .
•
ON: Sets the current channel as the scanning priority
channel.
•
Always: The user can transmit all the me.
•
Channel Free: The radio allows transmission only
when the current channel is free.
•
CTDS Correct: The radio can transmit when the
current channel is free or CTCSS/CDCSS is matched.
Mutes the speaker of the transceiver in the
absence of a speci c low-level digital signal. If the
sta on you are listening to does not transmit this
speci c signal, you
will not hear anything.
Transmits a speci c and con nuous subaudible
signal to unlock the squelch of a distant receiver
(usually a repeater).
Transmits a speci c low-level digital signal to
unlock the squelch of a distant receiver (usually a
repeater).
Edit the DTMF/ 2Tone/ 5Tone/ BDC1200 in the
PC programing so ware before it can be selected.
Press the PTT key to transmit the selected DTMF
ID/2Tone/ 5Tone/ BDC1200.
When the channel is set up for both CTCSS/DCS
decoding and op onal signaling, you can set up
the RX condi on in this menu.
Add the current channel to allow it to be scanned
This op on allows users to select a channel in the
scan list as Priority Channel. If only Priority
Channel is set, 50% of a radio's scans are on
Priority Channel during scanning.
This op on de nes the response from the
transmi er upon PTT press on the current
channel, in order to prevent the user transmi ng
on channels that are already in use.
Werbung
