Werbung
Appendix C. - Shortcut Menu opera ons
Main
Sub Menu
Menu
Sequence
Zone
1
1
2
3
Scan
4
5
1
Radio
Se ng
2
Sub Menu Name
•
Channel 1-Channel 64
•
+Add Zone: Add a zone and name the zone. The
Zone 1
newly added zone will default to one channel
430.12500 MHz
Up Limit-Down Limit
Freq Ranger
•
ALL: Scans all channels in the current zone.
•
MEMORY SCAN: Scans for channels that have been
Chan Ranger
added to the current zone
•
TO : Time Opera on – scanning will resume a er a
xed me has passed
•
CO : Carrier Opera on - scanning will resume a er
Scan Mode
the signal disappears
•
SE : Search Opera on - scanning will not resume
•
CTCSS: scan CTCSS (Scanning range 67-254.1)
Scan SubCode
•
DCS: scan DCS
•
ENCODER: Saved in TX CTCSS/DCS only.
•
DECODER: Save only in RX CTCSS/DCS.
Scan Memory
•
ALL: RX_TX are saved (default is all, i.e., encoding
and decoding are the same)
•
OFF
Squelch
•
Level 1-Level 9
•
OFF
Power Save
•
1:1|1:2|1:4
Se ngs
(Scanning range 023N-754I)
Descrip on
Stored zone, at least one zone saved.
Set up to 10 zones and store up to 64 channels
per zone.
No ADD ZONE op on when store up to 10 zones.
Se ng the upper and lower limit values of the
frequency scan range
In channel mode, the channel scan range is
selected. All channels in the current area or
added channels when allowed
Scanning Resume Method
Scanning for CTCSS/DCS of known frequencies
This func on is helpful to decode a CTCSS/DCS
tone if you don't know the exact code.
Squelch silences the receiver when there is no
signal.Se ng the squelch to 0 will open up the
squelch en rely.
Selects the ra o of sleep cycles to awake cycles
(1:1, 1:2, 1:4). The higher the number the longer
the ba ery lasts. The higher number increases
the RX sleep cycle, but you may miss the rst few
syllables before the RX opens.
Werbung
