Werbung
Add up to 10 zones, add a full 10 zone will automa cally hide the "Add Zone" op on.
7.3.2 Power On Displya Se ng
• Picture: The radio will display a preset picture when powered on. Picture requires .bmp format, size size 160*128 pixels
• Message: Through CPS programming so ware, General Setup>>General Setup>>Power On Character.
Or through self-sta on setup, press the
key >> Radio Se ng >> Power On Message.
• Voltage:The power voltage is momentarily displayed.
7.3.3 Display Reversal
For ease of use in di erent work scenarios, the radio's display interface can be oriented STAN and FAIL model.
Press
key >> Radio Se ngs >> DIR
-STAN: Normal display mode, suitable for desk or handheld scenarios.
-FAIL: the display interface is reversed, applicable to shoulder or waist-mounted scenarios.
7.3.4 MDF-A/ MDF-B Channel Mode A Display
[A][B] MR/Channel Mode Display Format.
Freq: Displays programmed Frequency
Name: Displays the channel name.
CH: Displays the channel number.
7.3.6 Alarm Model
You can select the type of indica on when an alarm is ac vated from the following op ons.
Press the key >> Intercom Se ngs >> Alarm Type.
-On Site: the alarm tone is given locally and the control center and group members will not receive the alarm signal.
-Code+Sound: A er sending an alarm code to the control center and group members, it will automa cally ac vate the hot micro phone and
send a background tone. The receiver will hear the background sound of the alarm. There are no other audible or visual indica ons.
Werbung
