Werbung
Using the menu with short-cuts
(1) Press the
key to enter the menu.
(2) Use the numerical keypad to enter the number of the menu item.
(3) To enter the menu item, press
(4) For entering the desired parameter you have two op ons:
a) Use the arrow keys as we did in the previous sec on; or
b) Use the numerical keypad to enter the numerical short-cut code.
(5) And just as in the previous sec on;
a) To con rm your selec on, press and it will save your se ng and bring you back to the main menu.
b) To cancel your changes, press and it will reset that menu item and bring you out of the menu en rely.
(6) To exit out of the menu at any me, press the key.
(7) All further examples and procedures in this manual will use the numerical menu short-cuts.
+ 1: Quick access to Zones selec on, up to 10 Zones are stored, each zone stores 64 channels;
+ 2: Quickly enter the Scan Se ngs. You will be able to set the VFO frequency range, Scan mode, Scan Sub-Code, Scan Memory;
+ 3: Quickly enter the Radio se ngs (general se ngs of the radio);
+ 4: Quick access to Program Channel (Alias, TX and RX Frequency, TX Power, Bandwidth, Display mode, Channel Memory and Channel
delete);
+ 5: Quickly query the radio informa on (ANI ID, Firmware version, Hardware version);
+ 6:Quickly enter GNSS posi on system se ngs (GNSS switch, me zone se ng, posi on mode se ng)
The menu parameters also have a number associated with them, see Appendix B, Menu de ni ons for details.
7.3 Radio General Se ngs
7.3.1 Add Zone
Press the [VFO/MR] key to Channel Mode, press the
The newly added zone will be automa cally con ured with a channel, allowing parameters such as Channel Name, Receive Frequency,
Transmit Frequency, Receive and Transmit CTCSS/DCS to be reset via the Channel Con gura on menu.
the key.
key >> Zone >> Add Zone, name the newly added zone and save it.
Werbung
