Werbung
Make sure you can hear the DTMF side
tone from the radio speaker, set to DT-ST,
2TONE signaling enabled for current
5TONE signaling enabled for current
MDC1200 signaling enabled for current
BDC1200 signaling enabled for current
Chapter 5. Basic Opera ons
5.1 Power on the radio
• Turning the unit on
To turn the unit on, simply rotate the Volume/Power knob clockwise un l you hear a "click". If your radio powers on correctly there should be
an audible double beep a er about one second and the display will show a message or ash the LCD depending on se ngs for about one
second. Then it will display a frequency or channel. If the Voice prompt is enabled, the voice will announce "frequency mode" or "channel
mode".
• Turning the unit o
Turn the Volume/Power knob counter-clock wise all the way un l you hear a "click". The unit is now o .
5.2 Adjus ng the volume
To turn up the volume, turn the volume/power knob clock-wise. To turn the volume down, turn the Volume/Power knob counter-clock-wise. Be
ANI-ST, DT+ANI.
channel/frequency
channel/frequency
channel/frequency
channel/frequency
CTCSS enabled
DCS enabled
Reverse func on enabled
R
Enables access of repeaters in VFO/Frequency Mode. TX
will be shi
Enables access of repeaters in VFO/Frequency Mode. TX
will be shi
Talkaround has been ac ated,
turntable. The transmission frequency is equal to the
T
d higher in frequency than RX
d lower in frequency than RX
Narrowband enabled
Scan enabled
grid at the central
receive frequency
Werbung
