Werbung
23
PTT-ID
24
PTT-DLY
25
ALERT
26
TAIL
Press/LongPress
27-30
SK1
•
OFF: No ID is sent.
•
BOT: The selected S-CODE is sent at the beginning.
•
EOT: The selected S-CODE is sent at the ending
•
BOTH: The selected S-CODE is sent at the beginning
and ending.
100-2500ms
100ms
•
•
1000Hz
1450Hz
•
•
1750Hz
2100Hz
•
•
OFF
55Hz:
•
•
120
180
•
240°
•
None:No Func on
•
SCAN:Scan on/o
•
Monitor:Monitor the weak signal.
•
FM Radio: FM Radio on/o
•
SOS: Long press the key to start alarm, short press
again to exit the alarm.
•
GNSS System: GPS on/o
•
One Touch Search: One Touch Search on/o
•
1750Hz:
•
Falling Alarm:
•
One Touch Call
•
Zone:In standby, press the programmed "Zone
Select" key, it will allow you input the zone number
and then press con rm key will switch to the zone.
•
Ba ery Display:Check the current ba ery capacity volt
age
•
Power:Switch the power between super high, high, mi
ddle and low power.
•
VOX:Set up the VOX level
When to Send PTT-ID Codes are sent during
either the beginning or ending of a transmission.
This func on allows you to set the delay in
sending the ANI code once the PTT is pressed (ANI d
elay).
You can set it between 100 and 25
Alert frequency is used to ac vate some dormant
repeaters, 1000Hz, 1450Hz, 1750Hz, 2100Hz a
total of 4 op ons are o ered.
This func on is used eliminate squelch tail noise
between BaoFeng handhelds that are
communica ng directly (no repeater).
Recep on of a 55 Hz or 134.4 Hz tone burst
mutes the audio long enough to prevent hearing
any squelch tail noise
This part allows users to assign your desired
features as shortcut to some keys of the radio.
The programmable bu ons vary with di
radios. Every key corresponds to two kinds of
opera ons: long press or short press. They can be
associated to di
features or the same
feature.
00ms.
Werbung
