Werbung
Method 1: Press
key go to the main Menu -> Radio Se ngs -> Press/ Longpress of "SK1/SK2" as [FM Radio], and turn on or o the radio by
pressing the preset [FM Radio] key.
Method 2: Press
key go to the main Menu -> Radio Se ngs ->Radio On/O , turn the radio on or o .
A er turning on the radio func on, the sta on search method is as follows:
-Press
key to enter radio search mode, the screen displays 'Seeking...', the radio will automa cally save the searched radio frequency as a
radio channel (memory mode).
-Press
or
to select the radio channel.
-Directly input familiar radio frequency by numeric keys (frequency mode, e.g. 96.9MHz, input 969)
-Short press the preset [FM Radio] key or
The frequency ranges to listen to the radio is 65-108MHz. When listening to broadcast FM, press
76-108 MHz band.
5.11 Radio Interrupt
On: When FM radio is used, you can s ll receive or transmit on the channel.
O : When FM radio is used, the radio will not permit a transmission or recep on.
5.12 Monitor
In standby, Press the pre-programmed [Monitor] key to enter Monitor. When receiving matched carrier but the signaling or the signal is too
weak, this func on allows monitor the weak signal.
Press the pre-programmed [Monitor] key again to turn o the speaker and exit the Monitor mode.
5.13 Keypad lock
The radio features a keypad lock that locks out all keys except for the three side keys.
To enable or disable the keypad lock, press and hold
You can also enable so that the radio automa cally locks the keypad a er ten seconds from the menu.
5.14 Frequency reversal
A short momentary press of the key enables the reverse func on
If you for some reason want to listen to the repeater's input frequency instead, press
receive frequencies.
key to exit the radio mode.
the key for about two seconds.
key switches between 65-75 MHz and
key momentarily and you'll reverse your transmit and
Werbung
