Werbung
will switch to channel 12.
When the voice prompt func on is enabled, the corresponding channel will be broadcast by voice.
5.7 Select a Zone
A zone is a group of channels with the same property. The radio supports up to 10 zones, with a maximum of 64 channels per zone. To select a
zone, do one of the following:
Press
key go to Menu > Zone, press
The corresponding regional alias will be displayed at the bo om of the screen.
5.8 Making a call
NOTE: Press the
key to switch the main channel to the other channel if there are 2 channels shown on the display. In standby mode,
press and hold the
key to switch between frequency (VFO) mode and channel (MR) mode.
• Channel mode call: A er selec ng a channel, hold down the [PTT] key to ini ate a call to the current channel. Speak into the microphone with
normal tone. Making a call, the red LED is on.
• Frequency mode call: Press and hold the
frequency range, and press and hold the [PTT] key to transmit on the current frequency. Speak into the microphone with normal tone. Making
a call, the red LED is on.
• Receive a call: When you release the [PTT] key, you can answer it without any ac on.
When receiving a call, the green LED is on.
NOTE: To ensure the best recep on volume, keep the distance between the microphone and the mouth at the me of transmission from 2.5
cm to 5 cm.
5.9 Emergency Alert
The Emergency Alert feature can be used to signal members in your group for help.
To ac vate the emergency alert func on, Press the pre-programmed [Emergency Alarm] key.
Press the pre-programmed [Emergency Alarm] to exit the emergency alert func on.
WARNING: The Emergency Alert feature should only be used in the even of an actual emergency.
5.10 FM Radio (FM)
or
naviga on key to select a zone, and then press
key to switch to the frequency mode, input the working frequency within the allowable
key to switch to the selected zone.
Werbung
