Installation Step 5 - Connecting To The Power Supply; Notes - Aqmos R2D2-32 Betriebsanleitung Und Programmieranleitung

Installation Step 5 – Connecting to the power supply

NOTES

Before commissioning the device, fill the cabinet housing with approximately 15 liters of water.
For detailed commissioning instructions, please refer to page 6.
Water should only be added during the initial installation. During regular operation, the system
will automatically fill with water during the regeneration cycle.
The water level should be about 1/3 of the system's height.
The dial on the control head indicates the operating status and does not need to be manually
turned.
Don't forget to open the bypass.
Airbags and bubble wrap inside the cabinet housing serve as transport protection and can be
easily removed.
Inside the cabinet housing or brine tank, there is a pipe with a lid containing a float valve. The float
valve serves as overfill protection and requires no adjustment.
If you have any questions, feel free to contact us via our website at www.aqmos.com or
www.aqmos.nl.
Your Water Treatment Team
AQMOS
1. Power supply connector.
23