How To Exchange The Batteries In The Remote Controller; Power Switch - Hitachi Ras-5182Ch Service

HOW TO EXCHANGE THE BATTERIES IN THE REMOTE CONTROLLER
Replace the batteries when the (battery) mark in the indicator of remote controller lights. _ _
Remove the cover as shown in the figure and |
take out the old batteries. :
Push and pull to the
direction of arrow ~
Install the new batteries.
The direction of the batteries should match
the marks in the case.
Press the @ "(TIME)" button three times.
A CAUTION
1.Do not use new and old batteries, or different kinds of
batteries together.
2.Take out the batteries when you do not use the remote
controller for 2 or 3 months.
4.The batteries must be of the LRO3 type.
TEMPORARY SWITCH
Use the temporary switch when operation cannot be
done with the remote controller.
1. By pressing the temporary switch, the operation is
done in previously set operation mode.
When the operation is done using the temporary
switch after the power source is turned off and is
turned on again, the operation is done in automatic mode.
2. When the operation is stopped or when the
operation is done with the remote controller again,
press the temporary switch once again.
POWER SWITCH
When you do not use the room air conditioner, set
the power switch to "OFF".
= 30-