Hitachi RAS-5182CH Service Seite 25

HOW TO SET THE SLEEP TIMER
Set the current time at first if it is not set before (see the pages for setting the current
time). Press the E] (SLEEP) button, and the display changes as shown below.
(Mode PPB eS Indication eos
Sleep timer ce hour ~+2hours — 3 hours -+ 7 hours
- Sleep time off ioe
oso
Sleep Ti Timer: The device will continue working for the designated
number of hours and then turn off.
Point the signal window of the remote controller toward the cooling
unit, and press the SLEEP button.
The timer information will be displayed on the remote controller. The
TIMER lamp lights with a beep from the cooling unit. When the sleep
timer has been set, the display indicates the turn-off time.
aC)
6)
°
1MOOeO
CANCEL
aml
AM ~~ = 7 .
x O ™ 4. EI Example: If you set 3 hours
mR atl sleep time at 11:38 p.m., the
turn-off time is 2:38 a.m.
The device will be turned off by the sleep
timer and turned on. by on-timer.
SLEEP
7 Set the ON-timer.
2 Press the &_] (SLEEP) button and set the sleep timer.
For heating: ©
O am
ee
|
In this case, the device will tum
7.8 i off in 2 hours (at 1:38 a.m.) and
| tum on early so that the preset
temperature be almost reached
at 6:00 next moming.
|. a.
How to Cancel Reservation
Point the signal window of the remote controller toward the cooling unit, and press the O (CANCEL)
button.
The © (RESERVED) sign goes out with a beep and the © (TIMER) lamp. turns off 0 on the cooling unit.
if you set the sleep timer when the off-timer or
on/off-timer has been set earlier, the sleep timer
becomes effective instead of the off-timer or on/
off-timer set earlier.
524