Hitachi RAS-5182CH Service Seite 60

Reset Circuit
Micro computer
K
ZZ C511
R512 . C5 (AX-3P)
DC 12V Line
TOV pa taree essere ehes ss
ie TV wen wn ge cn fn ww ee ee ew we ee ee we ee ene ee ee eee ne Goesken as
3 DC 5V Line
BV beneeeeeeneeee
4
POWER ON
Micro computer
Pin
Gace ne eee
Dee
The reset circuit is used to reset the program to its initial settings when the power is turned on or when the
power is recovered after a power failure.
The micro computer is reset when the reset input is "Hi", and operation is possible when the reset input is
"10": ae : er car es ' :
The waveforms at each point when the power is turned on and off are shown in the diagrams.
When the power is turned on, the voltages of the DC 12V line and DC 5vV lines are increased. When the
voltage of DC: 12V lines reaches about 7V, ZD511 is turned ON, the potential of Q511's base rises and Q511
is turned ON. Since Q511's collector is set to "LO" at this time, Q512 is turned OFF, Q513 is turned OFF and
the reset input of the micro computer is set to "Lo". The DC 5V line voltage has already become SV at this
-time and the micro computer starts operation.
When the power is turned OFF, the voltage of the DC 12V line decreases. When it becomes about 7V, ZD511
is turned OFF, then Q511 is turned OFF, Q512 is turned ON, Q513 is turned ON, the reset input of the micro
computer is set to "Hi" and the micro computer is set to the reset mode.
- 64 -