Hitachi RAS-5182CH Service Seite 11

The device will automatically determine the mode of operation, HEAT, COOL, or DEHUMIDIFY,
depending on the initial room temperature. The selected mode of operation will not change when the
room temperature varies.
press the FUNCTION ¢ shlodior so that the ceoey indicates
the © (AUTO) mode of operation.
@ When AUTO has been Selecied: the aves will
automatically determine the mode of operation, HEAT,
COOL, or DEHUMIDIFY, depending on vine current room
temperature:
@ The FAN SPEED selector does not Wore at this time: the
FAN SPEED is AUTO during HEAT and COOL, and LOW
during DEHUMIDIFY.
oO $O
Press the © (START/STOP) button.
START Operation starts with a bee
STOP / 5°. .
Press the button again to stop operation.
B As the settings are stored in memory in the remote controller, you
only have to press the © (START/STOP) button next time.
You can raise or lower the temperature setting as necessary by a
maximum of 3°C.
°C
Press and the temperature setting will change by
1°C each time.
@ The preset temperature and the actual room temperature may
vary somewhat depending on conditions.
@ The display does not indicate the preset temperature in the
AUTO mode. If you change the setting, the cooling unit will
produce a beep.
HI at start, MED or LOW
Over 27°C 27°C after the preset temperature
is reached.
3 Slightly lower than the
. Hi at start, MED or LOW
Under 23°C HEAT 23°C after the preset temperature
is reached
-10-