NAMES AND FUNCTIONS OF EACH PART
REMOTE CONTROLLER
This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor
lighting is controlled electronically, the range of control may be shorter.
This unit can be fixed on a wall using the fixture provided. Before fixing it, make sure the indoor unit
can be controlled from the remote controller.
TIMER selector
Signal emitting window/transmission sign
Point this window toward the indoor unit when controlling it.
The transmission sign blinks when a signal has been sent.
Battery warning sign
Replace the battery when this is blinking.
Display
This indicates the room temperature selected, current time, timer status,
function and intensity of circulation selected.
Timer controls
Use these buttons to set the timer.
TIME button
Use this button to set and check the current time.
FUNCTION selector
Use this button to select the operating mode.
Every time you press it, the
mode will change from €3(AUTO) to @ (HEAT) to 6 (DEHUMIDIFY) to
(COOL) and to -& (FAN) cyclically.
TEMPERATURE buttons
Use these buttons to raise or lower the temperature setting. (Keep pressed,
and the value will change more quickly.)
FAN SPEED selector
This determines the fan speed. Every time you press this button, the intensity
of circulation will change from © (AUTO) to & (Hi) to W (MED) to Y(Low
(during the + (FAN) mode, from
Hi to YW MED to Y Low).
AUTO SWING button
Controls the angle of the horizontal air deflector.
START/STOP button
Press this button to start operation. Press it again to stop operation.
FILTER button
Press this button when you have cleaned the filter. About 100 hours after this,
the FILTER lamp will light to indicate that it is the time to clean the filter again.
Battery compartment (at the back)
The batteries are in here.
SLEEP button
Use this button to set the sleep timer.
| 0 |
Precautions for Use
©@
Do not put the remote controller in the following places.
i:
® In direct sunlight
| 1 | SLEEPING
® In the vicinity of a heater.
| O | stor(cancey)
|
Handle the remote controller carefully. Do not drop it on the floor,
[1 | START(RESERVE) |
and protect it from water.
[@| stantstop
Once the outdoor unit stops, it will not restart for about 3 minutes
Pol me
(unless you turn the power switch off and on or unplug the power
cord and plug it in again).
This is to protect the device and does not indicate a failure.
AUTO SWING
if you press the FUNCTION selector button during operation, the
device may stop for about 3 minutes for protection.
|e
-
ey