Stihl FSA 70.0 R Gebrauchsanleitung Seite 44

English
Error LEDs on the
battery
3 LEDs light up
red.
4 LEDs flash
red.
The brushcutter 3 LEDs light up
cuts out during red.
operation.
The runtime of
the brushcutter is
too short.
The power levels
cannot be set.
Mowing head
cannot be atta‐
ched.
The mowing
head cannot be
removed even
though the
release button is
pressed.
Charging does 1 LED lights up
not start when steady red.
the battery is
inserted into the
charger.
19.2 Troubleshooting the Charger
Fault LED on Char‐
ger
Battery not being The LED fla‐
charged. shes red.
44
Cause
The brushcutter is too
hot.
There is an error in
the battery.
No electrical contact
between brushcutter
and battery.
The brushcutter or
battery is damp.
The brushcutter is too
hot.
There is an electrical
error.
The battery is not fully
charged.
The battery service
life has been excee‐
ded.
The trigger is pressed
and the brushcutter
switched on.
The release button on
the fanwheel is not
pressed.
The mowing head,
shaft or fanwheel is
dirty.
The release button
does not pop out and
remains pushed in.
The mowing head,
shaft or fanwheel is
dirty.
The battery is too
warm or too cold.
Cause
No electrical contact
between charger and
battery.
Remedy
► Remove the battery.
► Allow the brushcutter to cool down.
► Remove the battery and reinsert it.
► Switch on the brushcutter.
► If 4 LEDs continue to flash red: Do not
use the battery and contact a STIHL
authorized dealer for assistance.
► Remove the battery.
► Clean the electrical contacts in the bat‐
tery compartment.
► Insert the battery.
► Allow the brushcutter or battery to dry,
20.6.
► Remove the battery.
► Allow the brushcutter to cool down.
► Remove the battery and reinsert it.
► Switch on the brushcutter.
► Fully charge the battery.
► Replace the battery.
► Select the power level as described in
this User Manual.
► Press the release button.
► Attach the mowing head.
► Clean the mowing head, shaft and fanw‐
heel.
► Clean the mowing head, shaft and fanw‐
heel.
► If the release button remains pushed in:
Contact a STIHL authorized dealer.
► Pull off the mowing head from the shaft.
► Clean the mowing head, shaft and fanw‐
heel.
► Leave the battery inserted in charger.
The charging starts automatically as
soon as the permitted temperature range
is reached.
Remedy
► Remove the battery.
► Clean contacts on charger.
► Insert battery.
19 Troubleshooting
0458-063-9801-A