Adjusting Trimmer For User; Removing And Fitting The Battery; Switching The Trimmer On/Off - Stihl Fsa 70.0 R Gebrauchsanleitung

8 Adjusting Trimmer for User

► With the other hand, press the release button
until it engages.
The mowing head pops up from the shaft and
can be removed.
8 Adjusting Trimmer for User
8.1 Adjusting and setting the loop
handle
The loop handle can be set to different positions
to suit the height and reach of the user.
► Switch off the brushcutter and remove the bat‐
tery.
3
► Release the quick release clamp (2).
► Move the loop handle (1) to the required posi‐
tion and check that the following conditions
are met:
– The bump guard (3) fits between the loop
handle (1) and the control handle.
– The distance (a) of no more than 30 cm is
not exceeded.
► Close the quick release clamp (2) so that the
loop handle (1) cannot be rotated on the shaft
any longer.
9 Removing and Fitting the
Battery
9.1 Fitting the Battery
2
1
► Insert the battery (1) in the battery compart‐
ment (2) and press it home until you hear a
click.
Arrows (3) on battery (1) are still visible and
battery (1) is held securely in battery compart‐
0458-063-9801-A
a
1
2
3
ment (2). There is no electrical contact
between the trimmer and battery (1).
► Push the battery (1) into the battery compart‐
ment (2) as far as stop.
The battery (1) engages with a second click
and is flush with the trimmer's housing.
9.2 Removing the battery
► Keep one hand in front of the battery compart‐
ment so that the battery (2) cannot fall out.
2
► Press and hold the locking lever (1) with your
other hand.
The battery (2) is now unlocked and can be
removed.
10 Switching the Trimmer
On/Off
10.1 Switching on the brushcutter
► Hold the brushcutter firmly with one hand on
the control handle so that your thumb wraps
around the grip (2) of the control handle.
► Hold the brushcutter firmly with your other
hand on the loop handle so that your thumb
wraps around the loop handle or the handle
hose.
► Press the release slide (4) down with your
thumb and hold it there.
► Press the trigger (3) with your index finger and
keep it pressed.
The brushcutter accelerates and the cutting
attachment rotates.
You can now release the release slide (4).
If the ergo lever (1) is pressed, the trigger switch
(3) remains unlocked. This means that the trigger
English
1
1 2
4 3
39