Cleaning The Deflector And Cutting Attachment; Maintenance; Troubleshooting; Repairing - Stihl Fsa 70.0 R Gebrauchsanleitung

17 Maintenance

16.2 Cleaning the deflector and cut‐
ting attachment
► Switch off the brushcutter and remove the bat‐
tery.
► Clean the deflector and cutting attachment
with a damp cloth or a soft brush.
2
1
► Clean the groove (1) and mounting of the
shaft (2) with a damp cloth or a soft brush.
16.3 Cleaning the Battery
► Clean the battery with a damp cloth.
16.4 Cleaning the Charger
► Disconnect the mains plug from the power
supply.
► Clean the charger with a damp cloth.
► Clean vents with a paintbrush.
► Clean the charger's electrical contacts with a
paintbrush or a soft brush.
17 Maintenance
17.1 Maintenance Intervals
The maintenance intervals are dependent on the
environmental and operating conditions. STIHL

19 Troubleshooting

19.1 Troubleshooting the brushcutter or battery
Error LEDs on the
battery
The brushcutter 1 LED flashes
does not start green.
when switched
on.
1 LED lights up
steady red.
3 LEDs
flash red.
0458-063-9801-A
recommends the following maintenance inter‐
vals:
Every 12 months
► Have the trimmer checked by a STIHL servic‐
ing dealer.

18 Repairing

18.1
The trimmer, cutting attachment, battery and
charger are not user serviceable.
► If the trimmer or cutting attachment is dam‐
aged: Do not use your trimmer or cutting
attachment and contact your STIHL servicing
dealer.
► If the battery has a malfunction or is damaged:
Replace the battery.
► If the charger has a malfunction or is dam‐
aged: Replace the charger.
► If the connecting cable has a malfunction or is
damaged: Do not use the charger and have
connecting cable replaced by a STIHL servic‐
ing dealer.
Cause
State of charge of the
battery is too low.
The battery is too
warm or too cold.
The brushcutter has a
malfunction.
Repairing the Trimmer, Battery
and Charger
Remedy
► Charge the battery.
► Remove the battery.
► Allow the battery to cool down or warm
up.
► Remove the battery.
► Clean the electrical contacts in the bat‐
tery compartment.
► Insert the battery.
► Switch on the brushcutter.
► If 3 LEDs continue to flash red: Do not
use the brushcutter and contact a STIHL
authorized dealer for assistance.
English
43