Led On Charger; Assembling The Trimmer - Stihl Fsa 70.0 R Gebrauchsanleitung

English
6.5

LED on Charger

The LED indicates the operating status of the
charger.
If the LED glows green, the battery is being
charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.
7

Assembling the Trimmer

7.1 Attaching the deflector
► Switch off the brushcutter and remove the bat‐
tery.
1
2
3
The line limiting blade (2) has already been
installed in the deflector (1) and must not be
removed.
► Fit the deflector (1) on the housing (3) and line
up the holes.
► Insert screws (4) and tighten them.
The deflector (1) must not be removed.
7.2 Attaching the loop handle
► Switch off the brushcutter and remove the bat‐
tery.
1
9
4
8
7
► Insert the pin (8) into the opening in the quick
release clamp (5).
Align the pin (8) so that the notch of the pin is
at the bottom.
► Place the clamp (3) in the loop handle so that
the holes are aligned.
► Place the loop handle (2) with clamp (3) on the
shaft (9).
► Insert the long screw (7) through the holes in
the pin and quick release clamp (5).
38
4
2
3
5
6
► Press the clamp (4) against the shaft so that
the holes are aligned.
► Insert the short screw (6) through the holes.
► Insert the long screw (7) through the holes.
► Screw on the knurled nuts (1).
► Close the quick release clamp (5).
The loop handle (2) is properly adjusted if it can
no longer be moved.
► If the loop handle (2) can be moved:
► Open the quick release clamp (5).
► Tighten the knurled nuts (1).
► Close the quick release clamp (5).
The loop handle (2) can no longer be
moved.
► If the quick release clamp (5) cannot be
closed:
► Open the quick release clamp (5).
► Loosen the knurled nuts (1).
► Close the quick release clamp (5).
The loop handle (2) can no longer be
moved.
7.3 Mounting and Removing the
Mowing Head
7.3.1 Attaching the mowing head
► Switch off the brushcutter and remove the bat‐
tery.
1 2
3
4
► If the release button (1) is not pressed: Press
the release button (1) until it engages.
► Push the mowing head (4) onto the shaft (3)
and press it against the fanwheel (2).
The mowing head engages with a click.
The release button pops out, and the mowing
head fits flush against the fanwheel.
► If the mowing head does not engage: Press
the mowing head against the fanwheel and
rotate it until it engages.
7.3.2 Removing the mowing head
► Switch off the brushcutter and remove the bat‐
tery.
► Hold the mowing head firmly with one hand.
7 Assembling the Trimmer
0458-063-9801-A