Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Alarm
Test
Be sure to test your alarms when you turn them on for the first time, or when the group configuration has
changed. n addition to the weekly tests you shou d perform, it is recommended to test the a arm after
returning from a ong trip or vacation.
f your X-Sense XP02S-MRsmoke alarm is interconnected to other X Sense wireless alarms, we recommend
that every individual alarm is tested during the weekly test.
Test a Single Alarm
Action
Press the test/silence
button.
•Tap the Device Test button in its
Device Settings page in the app.
• The alarm will beep 3 times every
Indication
4 seconds.
• The LED will flash red during the
audible signa .
For devices
connected
to the base
station, a push notification will be
sent to your smartphone.
Then the alarm wil automatical y
enter standby mode.
NOTE
1. Thedevicesconnectedto the basestation can only be testedindividually. Theinterconnected devicesthat are not
connectedto the basestation can be tested byholding down the test/silencebutton on one of thedevices.
2. Thetest function accuratelytests thealarm'ssmokesensingcircuit without theneed to test with smoke.If your
smoke alarm fails to give an audible testsignal,pleasereferimmediately to the troubleshootingguide at theend of
this manual. Neverusean open flame to test this device.
Test
All Interconnected
Alarms
Hold
down
the Test/SiIence
button
for about
5
seconds.
he initiating unit will announce a voice "Dies ist ein
Test für al e Einheiten. Bitte bestätigen Sie,0b andere
Einheiten diesesTestsignal von der Standort
empfangen. Um abzubrechen, ösen Siedie
Test-/StummschaIttaste", paired with the LEDflashing
• Other interconnected
alarrms in the network W
receive the test signal after 5 seconds. They wil
announce a voice Testsignal empfangen von
Standort, kein echter Alarm", and beep continuous y
with the LEDflashing red and green successively.
f the initiating alarm is the model that does not
support interconnected voice test, other
interconnected a arms with voice function will say
Testsignal empfangen, kein echter Alarm."
• The testing of the units shou d be completed within
3 minutes.
After testing, the units will automatical y enter
standby mode.
.10.
Installation
Positioning
NOTE:Beforeinstallation, it isrecommendedto test theinterconnected alarmsin therooms whereyou intend to install
them to ensurethat they are within transmissionrangeand that nothing will interfere with their communication.
Study
Bedroom
Garage
Living Room
Laundry Room
Smoke
Alarms
CO
Carbon
Monoxide
Alarms
Heat
Alarms
Smoking Room
CD
Kitchen
co
o
o
Basement
Smoke
& Carbon
Monoxide
Alarms
co
e Extinguishers
•11
•
Werbung
