Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION
Display
Function
Switching the device on or off (10)
Briefly touching the button
Speed stage (5)
Five speed levels can be activated.
The speed steps are displayed as a ring segment. As the speed level
increases, the next ring segment increases in a clockwise direction.
Level 1 is shown here.
Regulation of the speed level (6)
Briefly touching the
mode, the turbo mode can be activated by touching the
Briefly touching the
Turbo (14)
The turbo speed level can only be activated in air purifier mode. TURBO
mode can be activated by touching the
level. The TURBO indicator (14) lights up continuously in the display.
TURBO mode can be deactivated by touching the
indicator (14) in the display goes out.
Set the desired humidity 30 – 70 %:
Press and hold button
(11) flashes continuously.
or
Use
Press and hold button
the relative humidity display (11) stops and the measured humidity in the
room is displayed again. Please make sure that the automatic mode (13)
is switched on (button
Automatic mode (13)
Is switched on or off by briefly touching button
On: Button
chapter "Displaying air quality") and humidity in the room, the appliance
automatically adjusts the fan speed. As soon as the desired humidity
level is reached, the disk stack does not rotate and humidification is no
longer carried out..
Off: Button
level 1 – 5.
(10) switches the device on or off.
button increases the fan speed. In the air cleaner
button decreases the fan speed.
(13) for 3 seconds. Relative humidity display
(6) to set the desired humidity (in 5 % steps).
(13) again for 3 seconds until the flashing in
(13) in the display flashes continuously).
flashes continuously. Depending on the air quality (see
lights up continuously. The appliance runs at the set fan
button again.
button again in the fifth speed
button. The turbo
(13).
EN
35
Werbung
