PUTTING INTO OPERATION
Before first use
1
Remove the appliance from its packaging and set it up. Remove the upper part
of the appliance (B) and place it with the top side on a soft, flat surface (e.g. a
carpet). Remove the transportation lock.
2
Open the locking mechanism in the upper part (B) of both filter inserts.
3
Pull out the two packaged filters (C) and remove the foil.
4
Then reinsert the filters so that the white loop is at the top and the white HEPA
filter is facing the outside of the upper part.
5
Close both latches.
The device must only be operated with
i
the filters installed.
6
Fill the water tray (F) in the lower part of 6 the appliance (H) with fresh tap water
up to the WATERLINE mark. Add 50 ml sample bottle of hygiene additive to the
water (total bottle contents).
The hygiene additive very important because with it the air is optimally
i
humidified.
7
Place the upper part of the device (B) on the lower part so that the gear wheels
of the upper and lower parts engage with each other.
1
2
EN
31