Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
MT
even when the power supply is
switched off.
• Worn or damaged information
signs must be replaced.
• Replace worn or damaged
parts for safety reasons. Use
only original spare parts and
accessories.
• Allow the motor to cool down
before you put the machine into
storage. Risk of burns!
Electrical Safety:
• Ensure that the mains voltage
matches the specifications on
the rating plate.
• Connect the equipment only to
a socket that has a
dual Current Device)
current of no more than 30 mA.
• Avoid bodily contact with
earthed parts (e.g. metal
fences, metal posts). There is an
increased risk of electric shock
if your body is earthed.
• Use only authorised power cables
of H05VV-F, which are no more
than 75 m long and suitable for
outdoor use. The power cable
wire cross section must be at least
2x1,0mm
2
. Always completely
unroll cable drums before use.
Check the cable for damage.
• To fix on the power cable, use
the cable suspension intended
for the purpose.
• Keep the power cable away
from the cutting tool when work-
ing. The cutting blades may
damage the power cable and
result in contact with live parts.
Always run the power cable be-
hind the operator.
32
RCD (Resi-
with a trip
The extension cable can be
accidentally severed. Risk of
electric shock!
• Do not use the power cable to
pull the plug from the socket.
Protect the power cable from
heat, oil and sharp edges.
• Switch off the equipment and
disconnect the plug from the
socket if the power cable is
damaged. If the power cable is
damaged, it must be replaced
by the manufacturer, the cus-
tomer services of the same, or
a qualified person, in order to
avoid hazards.
• Do not connect a damaged
power cable to the mains. Do not
touch a damaged power cable
when it is connected to the mains.
A damaged power cable may
result in contact with live parts.
Residual risks
Even if properly operating and han-
dling this electric tool, some residual
risks will remain. Due to its construc-
tion and build, this electric tool may
present the following hazards:
a) Injuries caused by moving
parts;
b) Ear damage if working without
ear protection;
c) Lung damage, if suitable res-
piratory protection is not worn;
d) Damage to your health caused
by swinging your hands and
arms when operating the appli-
ance for longer periods of time
or if the unit is not held or main-
tained properly.
Werbung
