Cleaning The Appliance; Interior Fittings - Gaggenau RB 289 Gebrauchsanleitung

Cleaning the appliance

m
Caution
▯
Do not use abrasive, chloride or acidic cleaning
agents or solvents.
▯
Do not use scouring or abrasive sponges. The
metallic surfaces could corrode.
▯
Never clean the shelves or containers
in the dishwasher. The parts may become
deformed!
Proceed as follows:
1. Before cleaning: Switch off the appliance.
2. Pull out mains plug or switch off fuse.
3. Take out the food and store in a cool location.
Place ice pack (if available) on the food.
4. Wait until the layer of frost has thawed.
5. Clean the appliance with a soft cloth, lukewarm
water and a little pH neutral washing-up liquid.
The rinsing water must not run into the light or
through the drainage hole into the evaporation
pan.
6. Wipe the door seal with clear water only and then
wipe dry thoroughly.
7. After cleaning reconnect and switch the
appliance back on.
8. Put the food back into the appliance.
Notes
▯
The water conduction channel A can be taken out
for cleaning. Regularly clean the condensation
channel and drainage hole B with a cotton bud
to ensure that the condensation can drain.
▯
After cleaning, the stopper must be re-inserted
into the drainage hole of the refrigerator
compartment for functional reasons.
38

Interior fittings

All variable parts of the appliance can be taken out for
cleaning.
Extendable glass shelf
1. Take out serving tray.
2. Detach glass shelf at front by lifting it out of the
rails.
3. Lift glass shelf at rear and take out.
Note
To insert extendable glass shelf, first place the back
of the shelf on the rails, feed it in and then engage at
the front.
Multi-level shelf
To remove the multi-level shelf, lift at the front, pull
forwards, lower and swing out to the side.
To insert multi-level shelf, first push into the rear
holders and then press down.